User manual

13
User manual CIBS Office 1g
NO
EN
NO
EN
14
User manual CIBS Office 1g
NO
EN
NO
EN
Factory default settings
This function will delete the stored pairing to the Blues II.•
Any settings made after you received the device will also be deleted.
Press and hold the pairing button •
9
. First you will hear a double
tone which indicates the device is set to pairing mode. You must
keep the button pressed until you hear the second double tone.
The flashing red and blue ligth will still flash •
Switch off the Blues II. When you switch the device on again, it will •
automatically go into pairing mode (the battery indicator light
6
will
flash alternately red and blue). This indicates that the device has
been reset to factory settings.
Trouble shooting and FAQ
The Blues II will not switch on!
Charge the battery•
The Blues II will not charge!
Make sure the charge plug is connected correctly in the Blues II and •
that the power supply is working.
I hear crackling!
For best possible quality the Blues II must be within range of the •
Tango VII.
If you are using headphones, make sure the plug to the headphones •
is correctly connected.
I cannot hear anything from the Blues II!
Increase the volume of the Blues II.•
Check that the Blues II is paired to the Tango VII.•
If you are using headphones, make sure the plug to the headphones •
is correctly connected. If you are using the hearing device, make sure
the coil is lying correctly around the neck and that the hearing device
is set to T or MT.
Will the Blues II and Tango VII work with other Bluetooth devices?
The Blues II and Tango VII is made to work with most Bluetooth •
products. This depends on the Bluetooth product being compatible
with Bluetooth version 1.1, 1.2 or 2.0, supporting headsets, handsfree
and/or A2DP profile.
programme (Blues II) …
Go to www.commidt.com to download both the operating •
instructions and the programme (CIBS Interface).
The CIBS Interface programme offers the following options:•
Turn on or off monitoring voice -
(enables you to hear your own voice)
Locate the serial number -
Useful tips:
Using the accompanying shirt/blouse clip can reduce noise caused by the
device rubbing off clothing. The clip can be attached to the rear of the
Blues II, in the slot on the desired side
By using the external microphone (accessory, article no: 901-001) you
can use the Blues II under your clothing, offering even better sound to
your audience. These and other microphones are connected at the
socket
Description of light diodes and colours
Battery indicator light
6
:
What you see What this implies for the Blues II
Solid blue light The battery level is between 100% - 20%
Flashing blue light
Incoming call (only when using the handset
lifter, accessory)
Flashing red light The battery level is below 20%
Solid blue light (while
charging)
Charging complete
Flashing red light (while
charging)
The Blues II is charging
Alternate blue and red
light
The Blues II is ready to pair