Use and Care Manual

9 HOMEDEPOT.com
Please contact 1-844-548-3776 for further assistance.
Installation (continued)
6
Mounting the light fixture
□ Close the xture by tightening the mounting
base screw (C) using a Phillips screwdriver.
CD
7
Caulking around the light
fixture
□ Caulk around the mounting base (D) and
surface with silicone sealant (not included).
NOTICE: Failure to properly caulk around the surface and mounting
base (D) could lead to water damage and is not covered under warranty.
NOTE: When attaching this xture (A) to an external,
surface mount junction box, caulk the inside of the light
xture before attaching to the mounting base (D).
D
Care and Cleaning
□ Shut off the main power supply before cleaning the product. To prolong the original appearance, clean the
light xture with clear water and a soft, damp cloth only.
□ Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints, solvents, or any other
chemicals on this light xture. They could cause a premature deterioration of the nish and may void the
warranty.
□ Do not spray the light xture with a hose or power washer.
Troubleshooting
If the light does not come on:
□ Verify that the power is turned ON from the circuit breaker and wall switch.
□ Verify the wiring for the xture is done properly.
□ Verify the line voltage is correct.
If the light ickers:
□ Do not wire to a dimming switch, use a standard ON/OFF switch.