Use and Care Manual

8
Installation (continued)
5
Making the electrical
connections
□ For handsfree operation, to allow both hands
to make electrical connections, use the hinge
on the mounting base (D) to hang the xture.
□ For the conduit mount installation, remove one
conduit plug (B) from the side of the xture
where the conduit will enter.
□ If necessary, strip 3/8 in. of insulation from the
junction box or xture (A) wires.
□ Connect the xture black wire to the supply
black wire ((+) line), and xture white wire
to the supply white wire ((-) common) by
inserting the exposed supply wires into the
corresponding Wago connector (E). Ensure
there are no loose wires.
□ Connect the supply ground wire to the green
xture ground wire by inserting the exposed
supply wires into the corresponding Wago
connector (E). Ensure there are no loose wires.
Junction Box Mount
Surface Conduit Mount
B
D
E
A
D
E
3/8 in.
(+) Line
Black
White
Lighting
Fixture
Green
(-) Common
Ground