Use and Care Manual

7 HOMEDEPOT.com
Please contact 1-844-548-3776 for further assistance.
Installation (continued)
4
Installing the mounting base
Junction Box Mount
□ Route the junction box wires through the
rubber center plug in the mounting base (D), by
pushing one wire through each hole in the plug.
□ Use the leveling bubble (F) inside the back
housing to adjust the mounting base (D) for a
level install.
□ Align the holes on the mounting base (D)
with the holes on your junction box. Use two
#8 screws (AA), depending on the size of
the holes in your junction box, to attach the
mounting base (D) to your junction box. (Fig. 2)
Surface Conduit Mount
□ Mark and drill two holes on the wall surface
as per the desired location for installing the
mounting base (D).
□ Use two or more suitable screws (not included)
applicable to the mounting surface and attach
the mounting base (D) on the surface.
F
A
D
AA
D