Item #1003 952 699 Model #STL15-4K-BZ USE AND CARE GUIDE STEALTH LED SLIM WALLPACK Questions, problems, missing parts? Before returning to the store, call Commercial Electric Customer Service 9 a.m. - 5 p.m., EST, Monday - Friday 1-844-548-3776 HOMEDEPOT.COM THANK YOU We appreciate the trust and confidence you have placed in Commercial Electric through the purchase of this LED wallpack. We strive to continually create quality products designed to enhance your home.
Table of Contents Safety Information......................................................2 Warranty.....................................................................2 Pre-Installation...........................................................3 Preparing for Installation...........................................5 Installation..................................................................5 Care and Cleaning......................................................9 Troubleshooting........................
Warranty (continued) LIMITATION OF LIABILITY In no event shall the manufacturer be liable for indirect, consequential, incidental or special damages, or lost profits. The manufacturer is not liable for any claims or damage arising out of or connected with the manufacture, sale, delivery, use, maintenance and repair or modification of the manufacturer products, or supply of any replacement parts that exceed the purchase price of the manufacturer products giving rise to a claim.
Pre-Installation (continued) HARDWARE INCLUDED NOTE: Hardware not shown to actual size. AA Part Description AA #8-32x3/4 in.
Preparing for Installation Review this information to ensure a successful installation: □□ The fixture can be mounted in the following two ways: □□ Junction Box Mount: Use an external junction box to mount the fixture. □□ Surface Conduit Mount: The fixture can be mounted directly on a wall surface using conduit entry. □□ When installing two fixtures on one switch, make sure the switch is rated for at least a 1A inductive load. □□ Do NOT wire to a dimming switch.
Installation (continued) 2 Removing the mounting base NOTE: The mounting base screw (C) comes pre-assembled on the light fixture. □□ Remove the mounting base (D) from the bottom of the fixture by loosening (do not fully remove) the mounting base screw (C) using a Phillips screwdriver.
Installation (continued) 4 Installing the mounting base Junction Box Mount □□ Route the junction box wires through the rubber center plug in the mounting base (D), by pushing one wire through each hole in the plug. □□ Use the leveling bubble (F) inside the back housing to adjust the mounting base (D) for a level install. □□ Align the holes on the mounting base (D) with the holes on your junction box.
Installation (continued) the electrical 5 Making connections □□ For handsfree operation, to allow both hands to make electrical connections, use the hinge on the mounting base (D) to hang the fixture. □□ For the conduit mount installation, remove one conduit plug (B) from the side of the fixture where the conduit will enter. □□ If necessary, strip 3/8 in. of insulation from the junction box or fixture (A) wires.
Installation (continued) 6 Mounting the light fixture □□ Close the fixture by tightening the mounting base screw (C) using a Phillips screwdriver. D C around the light 7 Caulking fixture □□ Caulk around the mounting base (D) and surface with silicone sealant (not included). D NOTICE: Failure to properly caulk around the surface and mounting base (D) could lead to water damage and is not covered under warranty.
Questions, problems, missing parts? Before returning to the store, call Commercial Electric Customer Service 9 a.m. - 5 p.m., EST, Monday-Friday 1-844-548-3776 HOMEDEPOT.COM Retain this manual for future use.
