Full Product Manual

Wall Mount Installation

Removing Mounting Bracket

Mounting the Crossbar

Connecting the Wires

Mounting Mounting Bracket

Mounting the Front Cover

□ Connect the power supply wires to the Back Plate (BB) wires

using the Wire Nuts (CC) Connect bare copper wire from Fixture

Back Plate (BB) to green or bare copper ground (house) wire,

neutral to white and hot to black. Feed the wires into the J-box.

□ Mount Mounting Bracket (BB) onto the Crossbar (GG). Hand

tighten the Fixture Nuts (FF) to secure it.

□ Remove the Front Cover (AA) from the Back Plate (BB)

by unscrewing the 2 Fixture Screws (EE) on the Front

Cover (AA). Then remove the Crossbar (GG) from the

Back Plate (BB) by unscrewing the 2 Fixture Nuts (FF)

holding the Crossbar.

□ Mount Front Cover (AA) and 2 Fixture Screws (EE) onto the

Back Plate (BB). Hand tighten the 2 Fixture Screws (EE)

with a screw driver. To prevent water or moisture from

entering the ﬁxture between

the ﬁxture and mounting

surface, waterproof silicon,

caulk or gel should be applied

to seal any gaps around

the junction point.

□ Make sure power is off. Mount Crossbar (G) onto J-box

using 2 J-box Screws (DD).

Turning Off the Power

□ Turn the power OFF at the switch and

fusebox or the circuit breaker.

AA BB