Installation Guide

9 HOMEDEPOT.COM
Please contact 1-844-548-3776 for further assistance.
Installation (continued)
6
Mounting the light xture and caulking
□ Close the xture by tightening the two mounting base
screws (C), using a Phillips screwdriver.
□ Caulk around the mounting base (D) and surface with
silicone sealant (not included).
NOTICE: Failure to properly caulk around the surface and mounting
base (D) could lead to water damage and is not covered under warranty.
NOTE: When attaching this xture (A) to an external surface
mount junction box, caulk the inside of the light xture before
attaching to the mounting base (D).
C
D
Operation
SELECTING DUSK-TO-DAWN OR SWITCH-ACTIVATED CONTROL
Option 1: Dusk-to-dawn operation
Dusk-to-dawn operation enables the light xture to automatically
turn ON when dark outside and turn OFF when the sun rises, thus
saving you energy.
□ To enable dusk-to-dawn operation remove the black
cap cover (F) installed on the xture and replace it with
the clear cap cover (CC). Also ensure the photocell (E) is
unobstructed.
□ Ensure the switch powering the outlet connected to the
light xture is turned to the ON position and leave it ON at
all times to enable dusk-to-dawn functionality to operate
automatically.
IMPORTANT: To test if the light xture (A) and photocell
(E) works properly run power to the xture and cover the
photocell to turn xture ON. Shine a light into the photocell to
see if xture turns OFF.
NOTE: If photocell (E) is located in an area under heavy
shade the photocell may not detect enough light and may turn
the light xture ON.
F
A
E
CC