Use and Care Manual

Installation (continued)
8
4
Making Electrical
Connections
If necessary, strip 3/8 in. of insulation from
junction box and lighting fixture wires (fig 7).
Affix the fixture hands-free hanging wire
hook (the metal cable found on the back of
the fixture) to the small U-shaped slot
located on the bottom of the mounting plate
(F) (fig 8). This hanging wire allows the fixture
to hang in place while freeing both hands for
your electrical connections.
(fig 7).
Hanging wire hook for
hands-free electrical wiring
F
(fig 8).
NOTE: Use the leveling bubble (E) inside
the mounting plate (F) to adjust mounting for
a
level install.
WHEN DIRECT SURFACE MOUNTING
USING SIDE CONDUIT ENTRY WIRING
(No junction box present)
Mark and drill two to four holes on the
wall surface as per the desired location
for attaching the mounting plate (F).
Use two or more suitable screws (not
included) to attach the mounting plate
(F) to the surface. (fig 9)
(fig 9).
F
E
AA
☐
☐
☐
☐