Use and Care Manual

7
Installation (continued)
2
Removing the
Mounting Plate
Loosen the mounting plate tightening screw (C)
using a hex head screwdriver (CC) and
remove the mounting plate (F) from the
fixture. (fig.5)
3
Installing the
Mounting Plate
(fig 6).
FOR MOUNTING TO A JUNCTION BOX
Route the junction box wires through
the large center hole in the mounting
plate (F).
Align the holes on the mounting plate
(F) with the holes on your junction box.
Use two #8 screws (AA), depending
on the size of the holes in your junction
box, to attach the mounting plate (F) to
your junction box. (fig.6)
NOTE: Use the leveling bubble (E) inside the
mounting plate (F) to adjust mounting for a
level install.
F
AA
F
C
CC
(fig 5).
NOTE:
The mounting plate tightening screw (B)
comes pre-installed on the light fixture.
The tightening screw should not be
completely removed.
E
HOMEDEPOT.com
Please contact 1-877-527-0313 for further assistance.
☐
☐
☐