Use and Care Manual

6
Pre-Installation (continued)
Installation
Wall Mount
1-1/2 in. 1-1/2 in.
Round Octagonal/Square
NOTE: Mounting base (D) mounts to recessed
mounted standard junction boxes or to the surface
directly. Junction box must be at least 1-1/2 inch
in depth for proper installation for recessed
mount application (fig 1).
(fig 1).
The fixture can be mounted in the
following two ways:
˜ Junction Box Mount: Use a junction
box to mount the fixture.
˜ Surface Conduit Mount: The fixture
can also be mounted directly on the
wall surface using conduit entry.
When mounting fixture, for Dusk
to Dawn operation, make sure the
photocell orientation is at the top for wall
mount, in an area that receives daylight
and not too close to reflective surfaces.
When installing two fixtures on one
switch, make sure the switch is rated for
at least a 1A inductive load.
If dimming, use with 0-10V dimming
switch.
1
Shut off electric power
Verify wall switch is in OFF position (fig 2).
the circuit breaker that supplies power
At the main electrical panel, turn off
to the junction box you are working on
(fig 3).
For screw-in type fuses, unscrew the
fuse that supplies power to the junction
box you are working on (fig 4).
(fig 2). (fig 3). (fig 4).
☐
☐
☐
☐
☐
☐
☐