Use and Care Manual

(Non-Dimming Wiring Diagram)
Surface Conduit Mount
Junction Box Mount
(0-10V Dimming Wiring Diagram)
10
Installation (continued)
Connect lighting fixture black wire to
junction box black wire (line), lighting fixture
white wire to junction box white wire
(common), and the lighting fixture green
wire to the junction box ground wire (fig 11).
For the purple and gray fixture wires either
leave the wires unstripped or individually
terminate fixture’s purple and gray wires
with wire nuts to prevent shorting (fig 11).
NOTE: Leave purple and gray wires terminated and
separated when NOT connecting to a 0-10V dimmer.
DO
NOT connect the purple and gray wires to any
other wire unless wiring to a 0-10V dimmer.
FOR NON-DIMMING ELECTRICAL WIRING
(Follow these steps when NOT wiring
to a 0-10V dimmer).
TIP: Hold stripped ends near each other and align
any frayed strands (do not twist wires). Push the wires
into wire nut (BB) and use your fingers to twist the
wire nut clockwise until tight. Check for
tightness by pulling wires.
Black
(Line)
White
(Common)
Green
(Ground)
Junction
Box
Gray (-)
Dimming
Purple (+)
Dimming
Non-Dimming Wiring Diagram
(fig 11).
Follow this diagram when NOT wiring
to a 0-10V dimmer.
Black
(Line)
Purple (+)
Dimming
Gray (-)
Dimming
White
(Common)
Green
(Ground)
0-10V
Dimmer
Connect lighting fixture black wire to
junction box black wire (line), lighting fixture
white wire to junction box white wire
(common), and the lighting fixture green
wire to the junction box ground wire.
For dimming, when connecting to a 0-10V
dimmer, connect the lighting fixture purple
wire to the dimmer switch purple wire
(+ DIM) and the lighting fixture gray wire to
the dimmer switch gray wire (- DIM) (fig 12).
FOR ELECTRICAL WIRING TO 0-10V DIMMER
(Follow these steps when wiring to a 0-10V dimmer.)
Dimming Wiring Diagram (fig 12).
Follow this diagram when wiring to a
0-10V dimmer.
☐
☐
☐
☐