Installation Guide
WARNING:
Carefully read and understand the
information given in this manual before beginning the
assembly and installation. Failure to do so could lead
to electric shock, re, or other injuries which could be
hazardous or even fatal.
WARNING:
This product must be installed in
accordance with the applicable installation code by a
person familiar with the construction and operation of
the product and the hazards involved.
NOTICE:
Added weight of the device may cause
instability of a free-standing portable luminaire. This
device is not intended for use with emergency exits.
NOTICE:
For Suspension mount, Use the hook to
support the chain, not the electrical cord.
WARNING:
Changes or modications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
WARNING:
The unit is intended to be installed
directly beneath a ceiling-mounted receptacle, and
that excess cord should be kept out of the work space,
such as by securing it to one of the supporting chains
with a cable tie.
WARNING:
Ensure the electricity to the wires
you are working on is shut off. Either remove the fuse
or turn off the circuit breaker.
WARNING:
1. Do not install on radiant-heating type ceiling.
2. Voltage and current rating of shoplight: 120VAC
420mA 44W 60Hz
3. Maximum 4 units to be interconnected.
4. The maximum distance to the receptacle is
determined by the 5 foot length of cord provided.
5. Starts reliably to O°F
6. Suitable for operation in ambient not exceeding 40°C
Wireless Protocol
FCC Regulation
Operation 9
Specication 10
4
3
3
FCC Regulation
47 CFR § 2.1077 Compliance Information
Supplier’s Declaration of Conformity
Leedarson America, Inc. 300 Technology Court SE Suite 100; Smyrna, GA 30082 1-678-293-8382
Responsible Party
Contains FCC ID: 2AB2Q-LA02301
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20 cm between the radiator and any part of your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution: The user is cautioned that changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Unique Identier: LSI-LP08CW
2