Instructions / Assembly

Installation
Installation
Part Description
Fixture body
B
A
Canopy
TOOLS REQUIRED
Hardware not shown to actual size.
HARDWARE INCLUDED
4
Installing the canopy
5
Making the electrical connections
Safety Information
PACKAGE CONTENTS
Pre-Installation
Pre-Installation
BB
B
Quantity
1
1
NOTE:
Make sure the power is off.
□
□
Pull the supply wires down out of the outlet box
and through the wire hole of canopy(A).
□
Fasten the canopy (A) to the outlet box with the
outlet box screws (AA).
□
□
□
Ladder Gloves
Safety goggles
Phillips screwdriver Electrical tape
Wirestripper
B
Wrap electrical tape (not included) around the wire
connectors (BB), and ensure they are secure.
IMPORTANT SAFETY INSTRUCTIONS
(Save These Instructions)
Care and Cleaning
□
removing the fuse at the fuse box.
□
□
CAUTION: Do not use chemical solvents or harsh
may occur.
Use a dry or slightly dampened, clean cloth (use clean water, never use a solvent) to wipe the
interior and exterior surfaces of the xture.
AA
Outlet box screws
x 2
BB
Wire connectors
x 3
Knockout
AA
A
to the negative wires from the supply circuit, the positive
from the supply circuit, and the ground wire from
the wire connectors (BB).
6
Attaching the canopy to the wall
A
A
B
Canopy
screw
□
Raise the xture body (B) up to the canopy (A).
This xture body (B) can be up and down adjustable 90
degree by loosen the set screw, Once you adjusted to desired
angle, push the set plate to the top and tighten the set screw.
□
□
Secure the xture body (B) to the canopy (A) using the
screwdriver and screws.
x 1
CC
A
3
Installation
1
□
Loosen the canopy screws with the screwdriver
and separate canopy (A) from the xture body (B).
2
Preparing the canopy
□
Knockout the assembly hole on the canopy (A)
as needed.
Waterproof silicon
Mounting surface
Canopy
7
□
□
□
□
Read all instructions prior to beginning the
installation process.
Make sure the power is turned off at the
electrical panel box before beginning your
installation. Turning the power off at the wall
shock.
square x 2-1/8 in. deep metal octagon outlet box.
The box must be directly supported by the
building structure.
□
All electrical connections must be in accordance
with local codes and the National Electrical Code.
If you are unfamiliar with methods of installing
licensed electrician.
□
□
□
□
□
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
compliance could void the user’s authority to operate the equipment.
CAUTION:
Keep the lamp away from
materials that may burn.
WARNING: This lighting is suitable for wet
locations.
CAUTION: The LEDs in this product
are not replaceable.
CAUTION:
Do not connect this light xture
to a dimmer switch or timer.
A
B
Troubleshooting
Problem Possible Cause Solution
The power is off.
Make sure the power supply is on.
There is a faulty wire
connection.
There is a faulty switch. Test or replace the switch.
The light will not
illuminate.
Check the wiring. Contact a qualied and
licensed electrician if you are not comfortable
troubleshooting wiring problems.
A
CC
90° Adjustable
Set screw
Set plate
Moisture barrier pad
To prevent water or moisture from entering the xture
between the canopy and mounting surface, waterproof
silicon, caulk or grease should be applied to seal any
gaps around the junction point.
Installing the moisture barrier pad
Place and stick the moisture barrier pad (CC)
on the back of the canopy (A).
Disassembling the xture body
Warranty
3-YEAR LIMITED WARRANTY
THANK YOU
We appreciate the trust and condence you have placed in Commercial Electric through the purchase of this LED light
xture. We strive to continually create quality products designed to enhance your home. Visit us online to see our
full line of products available for your home improvement needs. Thank you for choosing Commercial Electric!
8 a.m. - 7 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday
1-877-527-0313
Questions, problems, missing parts? Before returning to store,
HOMEDEPOT.COM
Contact the Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
call Commerial Electric Customer Service
Retain this manual for future use.
USE AND CARE GUIDE
LED LIGHT FIXTURE
Item
#1003934466
Model #DW10235BK-C
Waterproong the xture (optional)
The manufacturer warrants this lighting xture against defects in materials and workmanship for a period
of three years from the date of purchase. If within this period the product is found to be defective in material
or workmanship, the product must be returned, with a copy of the bill of sale as proof of purchase, to the
original place of purchase. The manufacturer will, at its option, repair, replace, or refund the purchase
price to the original purchaser or consumer. This warranty does not cover light bulbs or the xture
becoming damaged due to misuse, accidental damage, improper handling and/or installation, and
specically excludes liability for direct, incidental, or consequential damages. As some states do not allow
exclusions or limitations on an implied warranty, so the above exclusions and limitations may not apply.
This warranty gives you specic rights and you may also have other rights that vary from state to state.
□
□
FCC responsible party name: The Home Depot/address: 2455 Paces Ferry Road Atlanta,Georgia 30339
/Telephone number: [phone].