Installation Guide

7 HOMEDEPOT.com
Please contact 1-844-548-3776 for further assistance.
Installation (continued)
5
Making the electrical
connections
□ If necessary, strip 3/8 in. of insulation from the
junction box or xture (A) wires.
□ Connect the xture black wire to the supply
black wire ((+) line), and xture white wire to
the supply white wire ((-) common) by twisting
the exposed wires together and using the wire
nuts (BB). Ensure there are no loose wires.
□ Connect the supply ground wire to the green
xture ground wire by twisting the exposed
wires together and using the wire nuts (BB).
NOTE: Hold stripped ends near each other and align any
frayed strands (do not twist wires).
Push the wires into the wire nuts (BB) and use your ngers
to twist the wire nut clockwise until tight. Check for
tightness by pulling wires.
A
(+) Line
Black
White
Lighting
Fixture
Green
(-) Common
Ground
3/8 in.
6
Mounting the light fixture
□ Place the light xture (A) onto the mounting
plate (D) so the top-sloped groove on the plate
rests on the top-sloped groove on the back of
the xture.
□ Verify the xture is ush with the wall and that
the photocell (B) points upward for wall mount.
□ Using the Allen key (CC), tighten the mounting
plate bolt (C) back through the hole on the
bottom of the xture (A) until the bolt rmly
pushes against the mounting plate (D).
B
A
D
C
CC
7
Caulking around the light
fixture
□ Caulk around the mounting plate (D) and
surface with silicone sealant (not included).
NOTICE: Failure to properly caulk around the surface and mounting
plate (D) could lead to water damage and is not covered under
warranty.
NOTE: When attaching this xture (A) to an external,
surface mount junction box, caulk the inside of the light
xture before attaching to the mounting plate (D).
D