Installation Guide

Installation (continued)

Removing the mounting plate

NOTE: The mounting plate (D) and mounting plate bolt (C)

come pre-assembled on the light xture (A) for shipping.

□ Remove the mounting plate (D) from the back

of the xture by loosening the mounting plate

bolt (C) using the Allen key (CC).

NOTE: Only unscrew the bolt (C) far enough to remove the

mounting plate (D). Do not fully remove the bolt (C).

Installing the mounting plate

□ Route the junction box wires through the large

center hole in the mounting plate (D).

□ Align the holes on the mounting plate (D)

with the holes on your junction box. Use two

#8 screws (AA), depending on the size of the

holes in your junction box, attach the mounting

plate (D) to your junction box.

□ Please make sure, the “TOP” is upwards.

□ Use the leveling bubble (F) on the mounting

plate (D) to ensure the xture is level.

Hanging the ﬁxture to the

mounting plate

□ Place the small sphere head of the hanger

wire (E) between the back of the small groove

located on the bottom of the center hole of the

mounting plate (D).

□ Ensure the photocell (B) is on the top part of

the xture (A) when installed.

NOTE: Ensure the light xture (A) can safely hang onto the

mounting plate (D) to allow for use of two hands to make the

wiring connections.