Installation Guide

4
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
Select a suitable location that can support the weight of the fixture. Determine the method for mounting the fixture before drilling, based on
the type of ceiling.
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing an existing light fixture or installing the new one.
Keyholes
1
Marking the mounting location
□ With help from another person, temporarily hold the fixture body (A) up to the ceiling to determine the best mounting position and
which knock out hole to use for wiring the fixture.
□ Mark two keyhole locations on the mounting surface. The distance between the two keyholes is 44.1-in(1120mm).
2
Making the electrical connections
□ Insert the hot and neutral wires from the electrical box into the wire connectors of the black and white wires from the fixture body (A).
□ Insert the ground wire from the electrical box into the wire connector attached to the green wire from the fixture body (A).
□ Cover the wire connections using the wire connectors (AA).
□ Wrap the wires with electrical tape for a more secure connection.
□ Position the wires back inside the electrical box.
Green(E)
Black(+)
White(-)
A
Installation
A
AA
Electrical box