Instructions / Assembly

Page 8
PROTECTION FROM HEAT AND MOISTURE
• Do not install your refrigerator in any location where heavy moisture is present or if
the location is not properly insulated. This refrigerator is not designed to operate in
temperature setting below 50°F.
• Location for the refrigerator should be on a hard surface and away from direct
sunlight and heat source, e.g., radiators, baseboard heaters, cooking appliances, etc.
STARTING YOUR NEW REFRIGERATOR
After cleaning your refrigerator thoroughly. Wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.
1. Insert the power supply cord into the socket.
2. Turn the thermostat dial to an initial setting of “5” for 15-20 minutes.
NOTE: · As the door gets pressed in during shipping, the gasket may have to be
reset. This is done to prevent the cool refrigerated air from escaping. If there
is a gap between the door gasket and the cabinet, set the gasket by gently
pulling it out of the seal gap.
SET UP & USE