Technical data

PROGRAMMING SECURITY CODE AND

CHANGING MEASUREMENT UNITS

For the Fluid Commander Dispensina Control

TEAR OUT THIS SHEET ALONG THE DOTTED LINE

and keep it in a secure place after initiblly entering

the security code and setting the measurement units.

TO PROGRAM YOUR SECURITY CODE

1, Turn on the control.

2. When the display shows - - - - press the following

keys:

DISPENSE, TOTAL,

most lower right station key,

and 0.1 key.

3. The display shows

PPPP.

4. Enter any four station key numbers: this Is your SecUri-

ty code.

5. Enter the same four numbers again lo activate the

control.

6. Record the sequence of numbers and keep in a

secure place.

TO CHANGE~MEASUREMENT UNITS

(Gallon, Quart or Pint only - controls measured In IlterS

cannot be changed)

1. Turn on Me control.

2. When the display shows - - - - press the following

keys:

DISPENSE, TOTAL,

most lower right station key,

and TOTAL.

3. The display shows LI and the station lights for the first

fluid glow.

4. Press the 0.1 key lo change the measurement units.

5. Press any station key for the next fluid, and press the

0.1 key to change units.

Press

TOTAL to end.

7. Enter your security code lo activate the control.

.a_