Specifications

- 54 -
5.7.3 Point table (Position data) Configuration
< Position data Configuration>
① For actuators with a stroke less than 1000mm, set
parameter PE02 (Feel length multiplication (STM)
(Multiplier) ) to 0000 and the STM value to x1.
For actuators with a stroke more than 1000mm, set
parameter PE02 (Feel length multiplication (STM)
(Multiplier) ) to 0001 and the STM value to x10.
② Configure position data (mm). Set to a value within the stroke range.

* If electronic gear parameters (PA05/PA06/PA07) are set according to“LECSA Operation Manual (Simplified
Edition)”,section 5.3.4 in positioning mode:
The smallest unit for actuator movement is 1[μm] (0.001[mm]).
①
②
③