Specifications

- 26 -
5.3.3 Parameter Configuration Method
Set the parameters for applicable actuator.
Refer to “LECSA Operation Manual (Simplified Edition)”,section 5.4.3 for recommended parameter values for
SMC supplied actuators.
However, when using position control mode (pulse input), do not alter parameters PE02/PE03/PE04/PE07/PE08/
PE10/PE11 from their initial values (Only change these parameters for Positioning mode (point table/program
method)).

PA05/PA06/PA07 Configuration Examples
① Parameters PA05/PA06/PA07 are configured under the “Basic settings (list)” tab.
② Select “Write All”.
③ Cycle the power off to on. The parameters will now be active.




②
①