Specifications

- 24 -
5.3.2 “Control mode selection”
When using Position control mode (pulse input)
Change the “control mode” from “Position control mode (pulse input)” to “Positioning (Point table)”.
① From the “Basic settings” tab and “Parameter Setting” window from the drop down selection “Control
mode selection” select “Positioning (Point table)



When using Position control mode (pulse input)
② Parameter PA01 will change to 000 under the “Basic settings (list)” tab.

Positioning mode (point table)
② Parameter PA01 will change to 006 under the “Basic settings (list)” tab.
③ Click “Write All”.
④ Click “OK”.
⑤ Click “OK” (Parameters will be enabled after cycling the power OFF→ON).
①