Specifications

- 18 -

5. Parameter Configuration using Setup software (MR Configurator
TM
)
This section describes the configuration procedure for main parameters using the setup software (MR
Configurator
TM
: LEC-MR-SETUP221E). See chapter 4 of the “LECSA Operation Manual” for parameter details.

5.1 PC Setup software (MR Configurator
TM
)



*1 Setup software version C5 or above is required.
*2 The setup software (MR Configurator
TM
: LEC-MR-SETUP221E)must be purchased as an additional item.
*3 The USB cable (LEC-MR-J3USB) must be purchased as an additional item.
5.1.1 Installation Method
Perform installation according to the “MR Configurator
TM
instruction manual” (Manual/ib0300079*.pdf) contained
on the setup software (MR Configurator
TM
) CD ROM. The “SETUP221” software will be added to the PC.

5.2 Basic driver set-up for Initial Test Drive
Switch on the 24 VDC and 230 VAC power supply to the LECSA driver and wait until the driver display flashes as
shown below.

  