Owner`s manual

Enter the maximum lease time in seconds

Select “OK”.

Addressing

The Addressing page displays information about your LAN IP

address and allows you to change the address and subnet

mask assigned to your Commander Pulse.

Note

You should only change the addressing details if your ISP asks

you to, or if you are familiar with network configuration. In most

cases, you will not need to make any changes to this

configuration.

Changing the LAN IP address and subnet mask

Select Router Configuration from the main menu.

1. From the submenu, click on IP Address. The following page

is displayed:

This page displays the current IP address and subnet mask

assigned to your Commander Pulse. The default LAN IP

configuration is IP address 192.168.1.1, subnet mask

255.255.255.0.

2. Click on Change Commander Pulse Address settings

here… The following page is displayed:

1. Click in the IP Address and Subnet Mask boxes and

type the new address details.

Note

Your LAN PCs must remain on the same subnet as your

Commander Pulse (that is, the subnet masks must be the same)

For more information about IP addresses and subnets, see IP

Addresses on page 193. If necessary, reconfigure the LAN PCs

so that their IP addresses place them in the same subnet as the

new Commander Pulse IP address. See Configuring Ethernet

PCs on page 202.