Owner`s manual

Configuring a DHCP ADSL connection – RFC 1483

If your ISP uses a DHCP DSL connection, your ISP may tell you to set

unique path and circuit numbers (called VPI and VCI) in order to connect

your Commander Pulse to the ISP’s Internet service. In most cases, your

Commander Pulse will use default settings, so you may not need to enter

these values.

Note

Your ISP will provide you with the VPI/VCI values necessary to

setup a DHCP DSL connection.

1. From the “ADSL Modem”: Types of Access page select “DHCP” ,

2. Click “Next>”. The following page is displayed

3. Select the option as indicated by your ISP. The following page is

displayed

4. Enter the VPI and VCI settings supplied by your ISP