Owner`s manual

78
4. Select PPPoA and Click Next>. The following page is displayed:
5. Enter the PPP username and password provided by your ISP. Type
them in the relevant boxes,
6. Click Next>. The following page is displayed:
The settings of VPI=8 and VCI=35 are the default settings. If your ISP has
supplied you with different values enter them here.
7. Click Next>. The following page is displayed:
This page confirms your PPPoA settings.
8. If you are happy with your settings, click Confirm Changes. The
Internet Access page is displayed.
Configuring a PPPoE ADSL connection
If your ISP’s Internet service uses PPPoE you need to set up a PPP login
account. The first time that you login to the Internet, your ISP will ask you
to enter a username and password so they can check that you are a
legitimate registered Internet service user. Your Commander Pulse stores
these authentication details so you will not have to enter this username
and password every time you login.
Your ISP may also tell you to set unique path and circuit numbers (called
VPI and VCI) in order to connect your Commander Pulse to the ISP’s
Internet service. In most cases, your Commander Pulse will use default
settings, so you may not need to enter these values.