Owner`s manual

214
CND is not working
For CND service to work on standard CO lines it has to be
enabled in both the telephone exchange and on the
Commander Pulse system. If the service is provided on the CO
line it must be programmed in the Commander Pulse. See page
109 for programming from the Management Application and
Page 177 for programming from the programming keystation.
When setting the system time it does not update
immediately
The time and date will not change until all external calls in
progress when the programming change is made have finished.
Is there any way of retrieving deleted messages?
Unfortunately there is no facility to retrieve DELETED Voicemail
messages.
Noise from the Keystation speaker.
There is an option on the BT Micro system to play the music you
provide for music on hold through the keystation speakers when
the keystation is not being used. This feature can only be used
when you provide an external music source. If the feature is
turned on and an external music source is not provided the
Keystation speakers may make a low-level noise. To stop
this, program the feature off. Do this by selecting the Program
key on the Keystation, scroll down and select 'Background
music' and select the 'OFF' option.
Keystation not working in another station
If the Commander Pulse system wiring has been extended a
Keystation can only be connected to any of the other hard-wired
stations if the correct wires have been extended through to the
telephone socket. The Keystation requires more wires to work
than an ordinary telephone. See page 17 for wiring instructions.
Keystation ‘Speakerphone’ does not appear to work
The keystation has probably been programmed for headset
use. Select the Program key and scroll to Headset mode. Select
Headset mode and select Headset off. Headset mode should
only be set on when a headset is connected to the headset
connection on the Keystation and this is to be used instead of
the handset.