Owner`s manual

182
Setting up your phone
• Connect the output plug of the mains adapter to the socket
on the back of the charger unit and the mains adapter to the
wall mains supply.
• Place the 2 rechargeable NiMH AAA batteries (included),
observing their polarities, into the battery compartment on
the handset. Slide the battery door firmly into place.
• Place the handset on the base unit and let the batteries
charge for a full 14 hours before using it for the first time.
Note
The handset may get warm during the initial charge.
Switch on/off your phone
To switch off the power of your phone press and hold
during standby.
To switch on the power of your phone press . The battery
icon will display in 10 seconds. If the battery level is too low, the
handset may not power up.
To set your handset’s clock
Your clock resets to 12:00AM or 00:00, depending on time
format you are using, each time you replace the batteries
or switch off the handset.
To set your clock:
1. Press MENU during standby.
2. Press to select DISPLAY, and then press OK.
3. Press to select CLOCK, and then press OK.
4. Press to change the HOUR, and then press
5. Press to change the MINUTE.
If you set the time format of your clock to 12 hours, go to step 6.
If you set it to 24 hours, go to step 7.
6. Press. Press to select AM/PM.
7. Press OK to confirm.
Set the clock to 12/24 hours
To change your handset’s time format:
1. Press MENU.
2. Press to select DISPLAY. Press OK.
3. Press to select TIME FORMAT. Press OK.
4. Press to select 12 HOURS or 24 HOURS.
5. Press OK to confirm.