Owner`s manual

176
4. Press the Scroll Down Key (Ô) until ‘20/50 Hz ringing' is
displayed.
5. Select '20/50 Hz ringing'.
6. Select the stations to ring at 50 Hz
The default is that all stations are set for 25 Hz ringing.
Inverting ringing cadences
The external and Internal ringing cadences can be interchanged
on a station by station basis.
1. From the Programming Station, press the PROGRAM Key
2. Select ‘System programming’.
3. Enter the System Programming Password and select
'Stations'.
4. Press the Scroll Down Key (Ô) until ‘Reverse Cadence ' is
displayed.
5. Select 'Reverse Cadence'.
6. Select the stations that require the cadences changed
Keypad Feedback
When off hook on an station fitted with a keystation, a
confirmation tone is played when a digit is pressed. This is so
that the user knows that a digit was dialed.
1. From the Programming Station, press the PROGRAM Key
2. Select ‘System programming’.
3. Enter the System Programming Password and select
'Stations'.
4. Press the Scroll Down Key (Ô) until ‘Keypad Feedback' is
displayed.
5. Select 'Keypad Feedback'.
Select the stations that require the confirmation tone to be
played.
To configure PSTN lines
There are various options to configure the PSTN line interfaces
on your system. It is recommended that these settings should
only be altered from the original settings if there has been a
change in the network connection.
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.
4. Enter the System Programming Password and select
‘Lines’.
5. Press the Scroll Down Key (Ô) until ‘PSTN Programming’ is
displayed.
6. Select ‘PSTN' programming’.
7. Select the desired option as detailed in the table below.
The options are either explained in the following pages or in
the referenced pages
Press the Hands-free Key to finish programming.