Owner`s manual

173
If external calls only are to be Diverted select 'External calls
only'
Miscellaneous system configuration options
To change the Programming Station
System programming can only be carried out at one keystation,
that is, the keystation connected to the Programming Station.
By default, station 20 is the Programming Station. The
Programming Station can be changed to any other station if
required.
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.
4. Enter the System Programming Password and select
‘System’.
5. Press the Scroll Down Key (Ô) until ‘Programming position’
is displayed.
6. Select ‘Programming position’.
7. Select the station you wish to have as the Programming
Station. The selected Programming Station is denoted by a
♦.
Press the Hands-free Key to finish programming.
Note
The programming position can not be assigned to the doorstation
port or the external music on hold port if installed..
To change the System Programming Password
The default System Programming Password (1111) can be
changed to any 4-digit number.
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.
4. Enter the System Programming Password and select
‘System’.
5. Press the Scroll Down Key (Ô) until ‘Change Password’ is
displayed.
6. Select ‘Change password’.
7. Select ‘Change’ and enter the 4-digit number you require.
8. Select ‘Confirm’.
Press the Hands-free Key to finish programming.
To configure unequipped line interfaces
The system assumes that available line interfaces have
exchange lines connected to them. If a line interface does not
have an exchange line connected ensure correct system
operation by un-equipping the line interface in system
programming, as follows:
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.