Owner`s manual

168
4. Enter the System Programming Password and select
“System”.
5. Press the scroll down key until ‘Remote Notification is
shown
6. Select “Remote Notification”.
7. Select “Retry attempts”.
8. Enter the value from 2 to 15 and press “Confirm”.
9. The default value is set at 2.
Selecting the Line Group that the Remote Notification calls are
to use
The outgoing line group to be used for remote notification calls
can be changed.
1. From the Programming station, press the PROGRAM key.
2. Press the Scroll Down key (Ô) until “System Programming”
is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select
“System”.
5. Press the scroll down key until ‘Remote Notification is
shown
6. Select “Remote Notification”.
7. Select “Outgoing group”.
8. Select the group.
Notification delay timer
The time interval between receiving a message and making the
first remote notification attempt is programmable. This is set at
15 minutes (900 seconds) in default and can be set between 1
and 30 minutes (60 - 1800 seconds).
1. From the Programming station, press the PROGRAM key.
2. Press the Scroll Down key (Ô) until “System Programming”
is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select
“System”.
5. Press the scroll down key until ‘Timers’ is shown
6. Select “Timers”.
7. Press the scroll down key until ‘Notification delay’ is shown
8. Select “Notification Delay”.
9. Enter the value between 60 and 1800 seconds and press
“Confirm”.
Notification interval timer
If a remote notification fails this is the time the system waits
before retrying the call. This is set at 5 minutes (900 seconds) in
default. The range is 1-15 minutes (60 - 900 seconds).
From the Programming station, press the PROGRAM key.
Press the Scroll Down key (Ô) until “System Programming” is
displayed.
1. Select “System Programming”.