Owner`s manual

165
The emergency codes are 000 and106. They cannot be
barred.
Both Classes 5 and 6 can be associated with the same station.
Class 5 cannot be associated with Class 4 stations.
To set up Class of Service access tables
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.
4. Enter the System Programming Password and select
‘System’.
5. Press the Scroll Down Key (Ô) until ‘Class codes’ is
displayed.
6. Select ‘Class codes’.
7. Select the ‘Table’ to which you want to assign codes.
(Table 2, Table 3, Allowed Table, or Restricted Table).
8. Select an ‘Index number’ and enter the code.
When entering a code an additional option is given on the
display of your keystation. This option is the “Any” key, which
when selected inserts the symbol “X” into the next character of
the code (number) you are entering. The symbol “X” will
represent any number (1 to 0).
9. Select ‘Confirm’ when the code is entered.
Press the Hands-free Key to finish programming.
To restrict stations during the day
With this feature, you can assign the stations to a Class of
Service that will operate when the system is in ‘Day Service’.
On power-up, all stations are in Class 1.
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.
4. Enter the System Programming Password and select
‘Stations’.
5. Press the scroll down key until ‘Restriction classes’ is
shown
6. Select ‘Restriction classes’.
7. Select ‘Day Class of Service’.
8. Select the Class you want to assign to the stations, (Class 1
– Class 6).
9. Select the stations to be entered in this Class.
Press the Hands-free Key to finish programming.
To restrict station during the night
With this feature, you can assign the stations to a Class of
Service that will operate when the system is in ‘Night Service’.
On power-up all stations are in Class 1.
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.