Owner`s manual

15
5. Press the Scroll Down Key (Ô) until ’Equipped lines’ is
displayed.
6. Select ’Line 2’. The symbol beside line 2 changes from
“
♦” to “◊“ indicating the line is not equipped.
Note
If you do not have a keystation see the “PABX Configuration
using the web interface” section in the Owner’s manual for
instructions on programming the number of equipped lines
Step 5 DECT Phones
Assemble your DECT Phone
Place the 2 rechargeable NiMH batteries size AAA 1.2V
750mAh (included), observing their polarities, into the battery
compartment of the handset.
Slide the battery door firmly into place.
Place the handset on the charger unit and let the batteries
charge for a full 14 hours before using it for the first time. The
handset may get warm during initial charge.
Register the DECT phones.
Press the “Page” button for 4 seconds. This button is located
on the front of the Commander Pulse. This places the
Commander Pulse in registration mode for 30 seconds.
Note
You will know that the Commander Pulse is in registration mode
when the power led flashes red and green
1. On the DECT handset, press ‘REG’ on the DECT
phone
2. Press ‘OK’ for ’REGISTER’
3. Enter the PIN number of 1234
4. Press ’OK’
The DECT handset is now registered to the Commander
Pulse
Page Button