Owner`s manual

155
A Configuring Your Commander Pulse via the
Keystation
To enter system programming
If your station is the Programming Station you have access to
the system programming options. If you select this option you
will be prompted to enter the System Programming Password.
If this option is selected from any other station the display will
show ‘Programming Refused’. Again, the default Programming
Station is station 20.
1. From the Programming Station, press the PROGRAM Key
2. Press the Scroll Down Key (Ô) until ‘System programming’
is displayed.
3. Select ‘System programming’.
4. Enter the System Programming Password to access
system programming.
System Setup Options
Displaying caller numbers and routing calls
Caller Number Display service is available on PSTN lines. If
you subscribe to this service, your network sends the telephone
number of callers to the Commander Pulse (provided the caller
has not elected to restrict the network from presenting their
number). The telephone number (or associated name) is
displayed on the ringing keystations.
The CND information is also shown if the station is equipped
with a standard phone which supports the service.
Your telephone number will also be presented to persons you
call, unless you restrict your number from being presented.
How a caller number is displayed at your station
1. The caller’s number will appear on the display of all
keystations programmed to ring for incoming calls.
2. If a name is associated with the number in either the
system speed dial store or the CND store the name will be
displayed.
3. A caller may choose to withhold their identity. In this case,
the display will show ‘Number Withheld’ instead of the
caller’s number or name.
4. If the number information is not available the display will
show ‘Number Unavailable’ instead of the caller’s number
or name.