Owner`s manual

14
Connecting to an external modem
I f you are connecting to the Internet via another modem (e.g.
iBurst, Cable modem etc) connect the Blue cable provided to
the Blue WAN connector on the back of the Commander Pulse.
Connect the other end of the blue cable to the LAN port on the
external modem.
Step 4 Connect the Power
Power up the unit by connecting the AC power adapter to the
Commander Pulse, connect the adapter to the power point and
turn on the power point.
Note
The power cable is designed so that it will only fit into one socket
on the back of the Commander Pulse unit. Do not force the plug
into the socket.
It takes approximately 1 minute for the Commander Pulse to
initialize. Wait until the power LED on the front of the
Commander Pulse unit is a steady Green light.
You can make telephone calls now.
WARNING
If you have one PSTN line only you need to change the system
programming so that the unequipped line position is not used. If
this is not done every second time you dial 0 for a line the call will
fail.
Programming instructions for Commander Pulses with one
PSTN line.
1. From the programming station (by default, it is station
20), press the “Program” button, located on the top left-
hand side of the display of the keystation.
2. Press the Scroll Down Key (Ô) until “System
programming” is displayed.
3. Select “System programming”.
4. Enter the System Programming Password and select
’Lines’.