Owner`s manual

137
Adding Port Filters
1. Select “Add TCP or UDP Filter”
The following screen is displayed
Enter the following parameters
- IP Source address
- IP Destination address
- IP Protocol, TCP or UDP
- Source port or range of ports (associated with
source IP address)
- Destination port or range of ports (associated
with destination IP address)
- Direction, Inbound or Outbound
2. Select “Apply”
3. Save the new configuration
4. Restart the Commander Pulse
Adding Raw IP Filters
Filters based on IP address and protocol only can be added to
the security level displayed.
1. Select “Add Raw Filter”
The following screen is displayed
2. Enter the following parameters
- IP Source address and Subnet Mask
- IP Destination address and Subnet Mask