Owner`s manual

129
Setting the Country
1. From the First Time Settings section of the Wireless
Network page, click Change your wireless first time settings
here… The first page of the wizard is displayed:
The number of valid wireless network frequencies varies from
country to country and you need to identify which country you
are operating the Commander Pulse in to ensure that your
network will transmit on the correct frequency. The setting for
the Australia is the default setting so you do not need to change
it.
From the Country drop-down list, select the appropriate country.
Click on the Confirm Changes> button to apply configuration
changes and move on to the next page in the wizard sequence,
which allows you to Select your Wireless Network Type.
Select your Wireless Network Type
The following page allows you to select the Institute of Electrical
and Electronics Engineers (IEEE) specification supported by
your network:
Each specification transmits at a certain speed (measured in
Mbits per second) over a specific frequency. The frequency
indicates the range at which wireless traffic can be transmitted
or received between the Commander Pulse and the wireless
PC(s).
Supported specifications are:
- 802.11B only – provides slower rates at a longer range
than 802.11G (11 Mbps in the 2.4 GHz band)
- 802.11G only – provides faster rates at a shorter range
than 802.11B (20+ Mbps in the 2.4 GHz band)
- 802.11B/G – supports both of the above specifications,
but 802.11G rates will be slower than they are in a G-
only network
To select a network type, click on a single radio button.