Owner`s manual

123
Configuring 64bit or 128bit encryption
The example set in this section is for 128bit encryption, however
the outline also applies to 64bit encryption.
1. Once you have selected your WEP encryption method
and then clicked Next>, the following page is displayed:
2. Click in the Key box and type a unique 26-character
hex network key, such as
A6F34B2CE5D68BE90A6F34B2CE.
3. Click Next>.
If you are following the First Time Settings wizard, the next page
in the wizard sequence is displayed, which allows you to
Configure Wireless Address Authentication
If you have accessed this page from the General Settings
section of the Wireless Network page, click on the Confirm
Changes button to apply changes and return to the Wireless
Network page.
Note
Hexadecimal or ‘hex’ numbers each have a value of 0 to 9 or A to
F. Each number represents four bits of binary data.
Note
If you selected 64bit, you will need to type a unique 10-character
hex network key.