System information

Discovering Devices Using a Range of IP
Addresses
A group of devices can be discovered all at once using an IP address
range. By providing the beginning IP address and the ending IP address
(or subnet mask), n-Command MSP can identify all devices within the
range capable of being managed. Use the following steps to discover
devices on the network using this method:
1. Navigate to the Devices tab at the top left of the menu.
2. Select Discover Devices from the Manage drop-down menu.
3. Select the IP address that the discovered device will use to access
the server from the Select An Interface drop-down menu. Each
server has four ports, enabling it to be connected to four different
networks.
4. Enter the Contact Interval to assign to the successfully discovered
devices. This interval is the delay time (in seconds) between each
attempt of the device to check-in with the server.
5. Select the connection method to use, either HTTP or HTTPS.
6. Enter the beginning IP address to start searching, in the Start IP
Address field.
7. Enter the ending IP address to complete the range, or enter a
subnet mask in the End IP or Subnet Mask field.
8. Select the Authentication for user name and password usage. If
the appropriate entry is not listed, select Edit and follow the steps
explained in Adding New Access Credentials.
9. Choose Start to begin the discovery process. (If the Start button is
not available for selection, it could be because not all of the
necessary information was provided. Go back through the fields
and data selection steps to make sure all entries are provided.)
10. A job is created to discover the devices using the criteria provided.
The status is shown in the Jobs tab menu. All devices located in
the IP address range meeting the requirements to communicate
with the server, will now appear in the Devices tab menu.
ADTRAN n-Command MSP v6.1 Help
61700841G1-1A