System information

Changing Network Settings
To edit the configuration of the n-Command MSP server, follow these
steps:
1. Delete the existing information for the server's Host Name, Default
Gateway, Pri DNS Server (primary), or Sec DNS Server
(secondary).
2. Enter the new information in the appropriate
fields.
3. Verify the changes have been entered correctly, and select Apply.
To change the configuration of an Ethernet port, follow these steps:
1. Select the appropriate Ethernet port tab (for example, ETH 0).
2.
Make the appropriate changes to the port's enable mode,
speed/duplex, address type, IP address, or subnet mask.
3. Verify the changes have been entered correctly, and select Apply.
ADTRAN n-Command MSP v6.1 Help
61700841G1-1A