Specifications

6.3. Configuration via SMS
The GSM commander provides functionality to provide some configuration changes to be
done via SMS message (from the administrator number only). Note that the unit cannot be
setup by SMS only. A PC is still required to perform the initial setup. Thereafter, some simple
changes to the setup may be done using SMS messages. Please note: The Configuration
SMS is NOT case sensitive.
The following operations can be performed via SMS message:
Set Administrator number
Clear Administrator number
Check Administrator number
Check Airtime
Add a number to the list
Remove a number from the list
6.3.1. Set Administrator number
This command can ONLY be sent from the administrator number(if one exists), otherwise it
can be sent from any number .
ADMIN SETADM 0831234567
This will store 0831234567 as the new administrator number. The GSM Commander will
reply with a confirmation message.
6.3.2. Clear Administrator number
This command can ONLY be sent from the administrator number.
ADMIN CLRADM
This will remove the current administrator number. The GSM Commander will reply with a
confirmation message.
6.3.3. Check Administrator number
This command can be sent from ANY number, and is useful to determine which number is the
correct administrator number.
ADMIN?
The GSM Commander will reply with the administrator number in the reply message.
6.3.4. Check Airtime
This command can be sent from ANY number, and is useful to check the amount of airtime
remaining on the unit. To check airtime, you must send:
ATCHECK
The GSM Commander will reply with a message detailing the current airtime.
© Polygon Technologies. All rights reserved Page 17