Installation guide

30 PegaRULES Process Commander Installation Guide v6.1 SP2
8. Review this page to learn about the tasks you complete to prepare your
application server before deploying the Process Commander applications.
These tasks are completed outside this Assistant. You can exit from this tool
to complete them, and then restart to continue beyond this point, or you can
continue with the Rulebase Setup phase immediately and complete the
Application Server Preparation later.
Note: When the Database Preparation is complete, Step 3, the Application
Server Preparation, and Steps 4-9 in the Rulebase Setup Phase can be
performed in either order or simultaneously. You can, for example, launch
the Rulebase Setup process in the Assistant and then configure your
Application Server while the Rulebase load process is running.
However, you must configure the application server and deploy the Process
Commander applications before you can complete Step 10, PRPC Final
Settings.
Important: You must be careful not to start the deployed Process
Commander applications while the Rulebase loading process is still running
on the database. Note that your application server may start the
application automatically when it is deployed. If the Process Commander
application attempts to connect to the database while the Rulebase is
loading, the database loading will not complete correctly.