TWO-WAY LCD AUTOMATIC TRANSMISSION REMOTE STARTER C O M B O W I T H F U L L A L A R M S Y S T E M i CS-580 FM User Guide A note concerning the battery inside the transmitter: Depending on the usage of the transmitter, the battery can last anywhere between 3 to 6 months. When the battery is low, the transmitter will emit two beeps in a repetitive cycle. At that point you should replace the battery with a new one.
Table of Contents Table of Contents ................................... 2 Introduction............................................. 2 Remote-Starting Your Vehicle ................ 3 Remote-starting................................. 3 Vehicle Presets ................................. 3 Driving Off ......................................... 3 Using the System.................................... 3 Arming and Disarming the System.... 3 Idle Mode........................................... 4 Turbo Mode.............
With many advanced functions, this product will satisfy any one your expectations from high-end commodity and security systems, without neglecting any standard feature commonly offered by entry-level starters. Remote-Starting Your Vehicle Remote-starting Press the START/STOP button for approx. 1 second. The parking lights will come ON and the remote control will play a melody to inform you that the System has received your signal. Approximately 5 seconds later, the engine will start.
Idle Mode Convenience feature: Idle Mode allows you to keep the engine running and the doors locked while you stop, for example, at a convenience store or for a short delivery. This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a convenience store, lock your vehicle and leave it running for the length of a run cycle while you are away.
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into the IGNITION ON / RUN and OFF positions. The parking lights will flash twice to indicate that the vehicle is now in Valet Mode. The L.E.D. will go out. Note: With the Remote Valet activated, the remote starter and alarm functions will be disabled. Start Attempts Indicator (Valet Mode) This reveals start attempts made while the vehicle was in Valet Mode.
Press and hold the UNLOCK button for approximately 3 sec. until the sound signal starts and the parking lights flash: this will unlock the doors before the sound signal starts. Or press and hold the LOCK button for approximately 3 seconds until the sound signal starts and the parking lights flash: this will lock the doors before the sound signal starts. Panic Mode will automatically shut down after 1 minute.
Remote Door Locks If your System was installed with the Remote Door Locks option, you will have the convenience of remote keyless entry. See section Arming and Disarming the System, earlier in this Guide, for further instructions on remote door locking and unlocking. Priority Door Access (Enabled by default.
Car Finder (Enabled by default.) When enabled, the Car Finder option will help you locate your vehicle by generating a pulsating signal through the horn or the siren. To hear the signal, press the LOCK and UNLOCK buttons simultaneously. This will cause a pulsating signal lasting for the time you keep the buttons pressed. Siren or Horn Chirp Timing The duration of the chirps can be adjusted at installation (from 5 to 200 ms). Safe Start (Disabled by default.
Missing a Start or a Stop Confirmation If you have not received a start or the stop confirmation after pressing the START/STOP button, simply press the LOCK button. Pressing the LOCK button will refresh the display and will confirm if the vehicle was started or stopped. The Start Confirmation Was Not Received If after remote starting the vehicle no confirmation was received, simply press the LOCK button, this will refresh the display.
display means that you are now in Level 1. Simply press the corresponding button to access the desired feature. To access a Level 2 feature, press and hold the FUNCTION button until you hear a “beep within three seconds of hearing the “beep”, release the FUNCTION button and press and release the FUNCTION button once more. will be displayed. This display means that you are now in Level 2. Simply press the corresponding button to access the desired feature.
Troubleshooting Poor Transmitting Range • Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…) • Metal: any type of metal will affect operating range. This includes the metal in the car. • The shape of the vehicle can affect range as well; vans in general have an especially poor range.
LCD Transmitter Operation (First Car Control) Basic Vehicle Operation FUNCTION BUTTON PRESSED ICON BUZZER LOCK 1 Beep UNLOCK 2 Beeps TRUNK or AUX 3 START * (see Runtime Options below) INSTRUCTIONS /DESCRIPTION Locks the doors and arms the Starter Kill (if installed) and the alarm. Unlocks the doors and disarms the Starter Kill (if installed) and the alarm.
a. Press the button to increase the value or to activate or deactivate a function or to toggle through the melodies. c. To save modifications, do not touch any buttons for approx 5 to 10 seconds. There will be a beep and the display will return to the time. b. Press the to decrease the value or to activate or deactivate a function or to toggle through the melodies.
4 minutes 9 minutes 15 minutes 20 minutes 25 minutes 30 minutes ENGINE RUNTIME LCD Transmitter Operation (Second Car Control) Basic Vehicle Operation FUNCTION BUTTON PRESS LOCK ICON 1 Beep + UNLOCK 2 Beeps + START + STOP + BUZZER + None DESCRIPTION Locks the doors and arms the Starter Kill (if installed) and the alarm. Unlocks the doors and disarms the Starter Kill (if installed) and the alarm.
Diagnostics – Parking Light Flash Table Flashes 1 2 3 4 5 6 8 10 1 – pause – 2 2 – pause – 2 ON solid ON 2 sec. • • • • • • • • • • • • • • • • • • • • • • • • • ON 3 sec. ON 4 sec. • • • ON 25 sec. • Irregular Constant flashes up to 30 sec. Constant flashes up to 60 sec. User Guide • Description Doors locked, Alarm and Starter Kill armed. End of Run Time. TRUNK button pressed Start signal received by the System. Cold Weather Mode cancelled.
