Owner`s manual

WIRING: 9-PIN Harness

Orange: (-) Negative Starter Disable / Anti-Grind Output

CUT

STARTER WIRE

STARTER

ORANGE

CONNECT TO

PRE-WIRED

OF ALARM

IGN. SWITCHED

BLUE

YELLOW

ORANGE WIRE

STARTER DISABLE

RELAY & SOCKET

IGNITION SWITCHED

"ON" & HOT THROUGH

CRANKING

BROWN

START OUTPUT

6-PIN HARNESS

FROM ALARM

MAKE CERTAIN TO

CONNECT BROWN

WIRE TO STARTER

MOTOR SIDE!!!

Orange/Black: (-) OEM Disarm Output

This wire provides a Ground pulse to disarm vehicles' Factory anti-theft system prior to a Remote Start. Connect this

wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch or at

the Factory Anti-theft control module.

WIRING: 6-PIN High Current Connector

PIN 1: BROWN: STARTER OUTPUT (30A)

PIN 2: GRAY: ACCESSORY or IGNITION 2 (30A) CAUTION!: CHECK ALIGNMENT

PIN 3: RED: BATTERY CONSTANT FUSED (30A) OF PLUG TO PINS. IF THE

PIN 4: RED: BATTERY CONSTANT FUSED (30A) HARNESS IS UPSIDE

PIN 5: PINK: IGNITION 1 (30A) DOWN, STARTER OUTPUT

PIN 6: WHITE (18 Ga.): (+) PARKING LIGHTS (10A) WILL BE CONNECTED TO

PARKING LIGHTS!

NOTE!: Use External Relays for High Current Ignition and/or Accessory

circuits greater than 30A. Failure to do so could result in damage to the

unit that is not covered under warranty.