Owner`s manual

WIRING: 9-PIN Harness

Green/Red: Remote Aux. Output 1 OR MAP-Mobile Accessories Protection (Optional, requires relay)

This is a programmable output that can operate two different ways: 1. (DEFAULT) A Remote Auxiliary Output that

provides a ½ Second (-) Negative pulse when Button #3 is pressed to open a Factory power trunk or hatch release. It

can function as an MAP output that provides a continuous (-) Negative output when in the system is put into VALET

PARK MODE. M.A.P. can be used to interrupt power/accessory wiring to prevent unauthorized access of the vehicle’s

audio or entertainment systems when Valet Park mode is ON. See Mobile Accessories Protection Diagram Below.

8685

IGN.

SWITCHED

3087A

START

IGN

ACC

CUT

OFF

105.5

wire of mobile accessories such as Audio system

Connect relay as shown to interrupt the power

RADIO

GREEN/RED

M.A.P. OUTPUT

MOBILE ACCESSORY PROTECTION

or Cellular telephone. The Alarm will disconnect

these accessories when in VALET PARK MODE.

Blue/Black: (-) Remote Aux. Output 2 (Optional, may require relay)

This wire provides a Momentary (-) Negative output when Button #3 (Trunk) is pressed and held for more than 2

seconds. Output stays on as long a remote button is held down. Connect to the Negative activation circuit of an

auxiliary module or device. If the circuit requires +12V, then a relay is required. RELAY WIRING: Connect the

Blue/Black wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of the

relay to the +12V positive device/circuit to be activated.

Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)

This wire activates when the unlock button on the remote is pressed a second time upon disarming. Connects to

unlock circuit for passenger door or doors when using special driver’s door unlock configuration. See DOOR LOCK

WIRING for special configuration options.

Orange: (-) Negative Starter Disable / Anti-Grind Output

This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the blue

wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect each half

to an Orange wire on the relay socket. This output is called Anti-Grind because it stays active during remote start

preventing the starter from grinding if the key is turned too far after the vehicle is running. See diagram on next page.