Owner`s manual

TACH FINDER & TACH PROGRAMMING STEPS

TACH FINDER:

1. Open hood (or Ground the Blue Hood Pin wire if no hood pin is installed)

2. Start Engine with the key.

3. Press the Program button for 2 seconds

4. Lights will begin flashing if the White/Red wire is connected to a valid tach

5. Once Tach is located then turn off engine and close hood to abort.

6. See Tach Reference programming.

TACH PROGRAMMING:

1. Open hood (Or Ground Blue wire if no hood pin installed.)

2. Connect WHITE/RED wire to a valid Tach source.

3. Start engine with key.

4. Press program button 5 times, then wait for 5 light flashes.

5. Wait at least one second then push program button again (1) time, you should get a light flash with the button

press. This unit is now at option #1-Tach Learning.

6. Press the #2 Unlock Button on remote transmitter. The unit will read and program the Tach source. The lights will

flash twice for confirmation.

7. If lights do not flash twice for confirmation, then try another tach source or try the tach finder.

PROGRAMMING – CS-2015FM TRANSCEIVER / CS-2011RS TRANSMITTER

Note: The CS2015FM will only learn LCD Transceiver Remotes and the CS2011RS will only learn 4

button CoolGlow™ transmitters! The remote controls for these systems are not interchangeable.

1. Open Hood (Ground the Blue wire if no hood pin is installed.)

2. Turn key to the ON position. (Doors will lock if Autolock is programmed)

3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.

4. Press button #1 (Lock) of the transmitter or transceiver to be learned. You should get 2 light flashes indication the

unit is waiting for a 2

code, then press button #1 of a second transmitter or transceiver, the unit will flash 3 times

indicating its waiting for the 3

code and lights will flash 4 times for 4

code. If all 4 codes are learned, the unit will

automatically exit code learning mode, otherwise turn key off and close hood.

Note: All transmitter codes must be learned at time of programming!! Up to 4 different transmitter

codes can be stored in the memory of the system.