User's Manual
figure 5 figure 6
figure 7 figure 8
14) Measure your vehicle and set level
The Settings screen should now be displayed (figure 4 or 5). Measure the
length and width of your vehicle as indicated by the front and side view vehicle
illustrations on this screen. Enter the length and width measurements in the
appropriate locations on this screen. Tap the Save button at the bottom right of
this screen to save the vehicle measurements. If you have power slideout
rooms and you leveled in step 9 with them out, put the slides in and then step
outside of the vehicle before proceeding. Next, tap the Set Level button at the
bottom left of this screen. The Set Level button records the current angle data
from the LevelMatePRO+ device and will be used as a reference each time the
system calculates and displays leveling data.
NOTE: For fifth wheel installations, the length measurement should be taken
from the center of the rear wheel to the center of the landing gear leg and NOT
to the king pin or hitch pin.