User's Manual

NOTE: If you ever uninstall/reinstall your LevelMatePRO in another vehicle
or in another location in the same vehicle, you will need to repeat this step
after the unit has been reinstalled.
15) Confirm setup is complete
After completing the Set Level task above, tap the yellow arrow at the top left of
the Settings screen to go back to the Leveling screen (figure 6 or 7). Note that
on Android smartphones and tablets there will be no yellow arrows at the top left
of the settings screens and you should use the back button instead. Once at the
Leveling screen check to insure that there are no up or down arrows displayed
and the height requirement dimensions are all displaying ‘0’. If you selected the
towable option, the round level indicators should be green. These items will be
your indication that the LevelMatePRO has properly recorded the current level
position. From this point on, each time you start the app to use the
LevelMatePRO the Leveling screen will be displayed instead of the Orientation
Select or Settings screen. Anytime you need to return to the Settings screens
you can do so my tapping the gear icon at the top right of the Leveling screen.
16) Set the advertising time
Navigate to the Orientation Settings screen in the app (figure 3) and tap the
yellow arrow in the upper right corner of the screen. This will take you to the
Advertising and Display Settings screen (figure 8). Input the number of hours
you would like the system to advertise the Bluetooth signal after the
LevelMatePRO no longer detects motion. The default and recommended
number of hours for this setting is 1, but you may decide that you need the
system to remain connectable for longer than that depending on your specific
use requirements. The greater the number of hours you use for this setting, the
shorter the battery life will be.
NOTE: Anytime you need to activate the LevelMatePRO and make it
connectable after it has discontinued advertising the Bluetooth signal,
simply slide the on/off switch to the off position and then back to the on
position where you should hear 2 beeps. This will be your indication that
the system is on and ready to use.