System information

G2T Programmers Guide Rev-A 17-Nov-2014
68
Error
Type
Description
40
F
Power supply #1 fault
41
F
Power supply #2 fault
42
F
Power supply #1 is missing
43
F
Power supply #2 is missing
47
E
Missing module in system
50
F
SPI “time-out” error caused by module not responding
52
F
SPI error (internal)
53
F
SPI error (internal)
54
F
SPI error (internal)
55
F
SPI error (internal)
56
F
SPI error (internal)
57
F
SPI error (internal)
58
F
SPI error (internal)
59
F
SPI error (internal)
61
C
Wrong 1
st
argument
62
C
Wrong 2
nd
argument
63
C
Wrong 3
rd
argument
64
C
Blank program message unit (IEEE-488.2 standard term)
65
C
Firmware issue (consult factory)
66
C
Invalid command header (IEEE-488.2 defined)
67
C
Command has too many arguments
68
C
Command has too few arguments
73
Q
Addressed to talk but has no response
74
F
US-Link Timeout
75
F
US-Link address wrong
76
F
US-Link bad command
77
F
US-Link remote has a fault
78
F
US-Link remote has an ongoing fault condition
79
F
Dual transition Fault CPU1 (Top) is alone
80
F
Dual transition Fault CPU2 (Bottom) is alone
81
F
Dual transition Fault CPU2 (Bottom) stopped responding
82
F
Dual transition Fault CPU1 (Top) stopped responding
83
F
Dual transition Fault CPU2 (Bottom) reset
84
F
Dual transition Fault CPU1 (Top) reset
85
F
Dual transition Fault CPU1 (Top) came up as secondary
86
F
Invalid mid-stage parameter. See note 4.
88
F
Dual processor firmware mismatch
Note 1: Faults 16, 17, 18, and 19 apply only to Master/Remote switching system.
Note 2: If error 28 does occur, try splitting the compound command with all those
QUERY? ALL commands and the *SAV into two or more commands.
Note 3: Errors 32, 33, 34 and 35 apply only to Tri-stage switching system.
Note 4: Fault 86 applies only to Tri-stage switching system.