System information

17-Nov-2014 G2T Programmers Guide Rev-A
63
6.2. System Switching Mode
The switching system can be enabled in two modes; AUTO-ROUTE
mode or GANGED mode. The mode of the system affects the
allowed syntax for the following operational commands:
• CONnect Makes a connection within the system.
• DISconnect Makes a disconnection within the system.
• QUEry Queries the complete system or a single
switchpoint.
Depending upon the system mode, these commands may or
may not require a module number in the command syntax
entered by the user.
6.2.1. Auto-Route Mode
The AUTO-ROUTE mode automatically routes the command entry
without the need to address a specific module number.
6.2.1.1. Output End to End System
The output end-to-end system assumes a single configuration that
may comprise one or several modules. The total number of
outputs and inputs of the system is the result of all modules
combined. The system is programmed to route automatically the
command entry to the correct module without the need to
address a specific module number. However, for diagnostic
purposes only, the user has the option to specify a module when
querying the system. The keypad on this type of configuration
automatically displays the following:
“AUTO-ROUTE”
Output End-to-End systems are configured in AUTO-ROUTE mode.