System information

G2T Programmers Guide Rev-A 17-Nov-2014
42
5.2.2.12. *IDN? command
This command returns an identification string.
*IDN?
Returns an identification string of the format:
Universal Switching,pppppppp,s,rrrrrrrrrr\n
where pppppppp is the model code, s is 0 (in lieu of a serial
number) and rrrrrrrrrr is the revision code. The model code and the
revision code are extremely important for resolving support issues.
Note that the revision code is subject to change with any firmware
updates/revisions.
5.2.2.13. *TST? command
This command performs a system self-test.
*TST?
The response is 0 if it completed successfully. A non-zero response
indicates the number of modules that were not in their proper
slots. Allow several seconds for the test to complete. As the result
of the self-test:
Routing to modules that were removed or have stopped
responding since the last reset or self-test generates an execution
error 47 instead of generating a fault.
Modules that were inserted since the last restart or self-test now
are used.
Interface setting made via the keypad or though SETs take effect.
5.2.2.14. *RST command
This command is the switchpoint reset command.
*RST
This command clears all the switchpoint routings in all the modules.
No other status registers are affected.